Network Related

These options set important network related features such as the NAT status and IP address from which UAD/Phone registers to PBXware

NAT (Network Address Translation):

Tell PBXware if extension is located behind NAT

Example: If extension 1000 is behind NAT in a remote location/network set this option to 'Yes'. If this option is not set to 'Yes' you may experience a 'one way audio problem'. Options to choose from:

•	Yes - Remote extension is behind NAT

•	No - Remote extension is not behind NAT (default value)

•	Never - Never attempt NAT mode

•	Route - Assume NAT but do not send rport

Field Type: Option buttons

Qualify:

Timing interval at which PBXware checks UAD/Phone availability

Example: This timing interval is set in milliseconds and it behaves like a 'ping' command. A request is send by PBXware and reply is expected from UAD/Phone. Default value for this option is 2500 (2.5 seconds)

Field Type: [0-9]

NOTE: To see availability of all PBXware extensions navigate to 'Monitor: Extensions' and check the 'Status' field which should be set to 'online/offline'. If 'unknown' is displayed, it means that this 'Qualify' value has not been set for the extension

Host:

UAD/Phone IP address

Example: If UAD/Phone is on a static IP set its IP address here e.g. 192.168.1.22. In case that UAD/Phone is on dynamic IP address, set 'dynamic' here

Field Type: [dynamic][0-9]

Default IP:

IP address used until UAD/Phone registers with PBXware

Example: This IP address, e.g. 213.22.30.200, will be used by PBXware until UAD/Phone registers on 'Host' IP address

Field Type: [0-9]